Client Encryption has no real answer

[EzraMcgrath]

Hello and thanks in advance,
I have been searching these forums for hours. I just did a fresh install of the latest RUNUO 2.0.
I downloaded the client encryption keys and the encryption packages recommended. I have tryed them all but settled with 2.2 because it does not give me the two errors that have been mentioned but once again never answered for anyone else who has posted about them. The errors 2.3 gives are on line 135 and 137 of the ENCRYPTION11JUN2008.CS both Server.Network.Listener does not contain a definition for endpoints.
Version 2.2 however works fine with the exception of one small problem. I get stuck at verifying account. The encryption message is not there anymore. The line actually says 1 online but it will stay there till i close the client and then it will say disconnected. Is there anyway to get this issue resolved? I have the latest RUNUO 2.0, I have followed all the instructions and tried all of the encryption packages version 1.1 through 2.3., and I have the latest OSI patch. Once again It is not disconnecting me but it might as well be. It is telling me I have the client connected and just sits there at the verifying account screen. I can actually log into the server if I just simply use the 127.0.0.1 address. The problem is when I try to use my ip address that players will actually have to use to log in, and yes I have had other players try with the same result. ANy help would be great thanks.

[test444]

I managed on RunUO 2.0 the client encryption issue without problems in the final... i just had to install the encryption script package, and client has to use Razor and check patch OSI encryption when Razor starts... if you cant connect to public IP its not probably issue of encryption, its problem of firewall or router.

[EzraMcgrath]

I think it is still an encryption problem. Is there a certain way you have to install the script? Are you using version 2.2?

[test444]

i was using farewell encryption from here, first there were some errors, but then everything was fine... but then i upgraded the server from RC 2 to SVN and i think that this server was working as default, but i have installed farewells encryption anyway.

[EzraMcgrath]

Ok. Thank you for your help I can now log into my shard. I used the key generator that allows you to type in the current version of UO that you are using. Then I added the key to the configuration.cs script and it let me log in. Now I cannot pick anything up and it freezes about 10 seconds after logging in to the world. Any ideas?